How To Use ImpelPro® Impeller Pullers

Removing an impeller doesn’t have to be a hassle. With ImpelPro pullers, you can quickly and safely extract any rubber impeller without damage to your pump. Below, you’ll find both a step-by-step video tutorial and illustrated instructions with a downloadable PDF for easy reference.

If you prefer step-by-step instructions with photos, scroll down for the complete guide and printable PDF.

If you prefer learning by video, here’s the full step-by-step video:

"Click the link to watch a longer video with even more information."
youtu.be/V1My2AtaSd0?si=Of92tNXQNg4dDHe-

Step-by-Step Instructions

Step 1

Diagram showing the different parts of the ImpelPro impeller puller

Lube the threads of the puller with any lubricant.
Insert a rod into the top part of the knurled thumbscrew.
Start with both arms parallel to each other.
Use the knurled thumbscrew to adjust the arms in or out.
Adjust the threaded rod to be flush at the bottom of the strong back.

Step 2

A large water pump with face plate exposed and screw driver prying the end cap from the impeller

From the pump body, remove screws and end cover plate.
Pop out the seal and expose the end of the shaft.
Locate the cam on the water pump housing.

Step 3

A water pump with impeller exposed with arrow pointing to cam and a green line going through the middle of the impeller with green check

Choose two points on the impeller that are directly across from each other and centered in the housing—this ensures the threaded rod aligns with the center of the impeller shaft.

Important: The tool must be centered to work properly. If it’s off-center or angled due to the cam, it will not pull the impeller and may damage the tool.

how not to insert impeller puller in the pump with red going through middle of impeller, but also into the cam.

Step 4

Water pump in a tight space with ImpelPro Impeller Puller inserted in the housing

Install the tool with the arms into the raw water pump.
Tighten down the thumb screw to set the arms into the impeller.
Turn the treaded rod in by hand until the tip of the rod reaches the impeller pump shaft.

Step 5

Hand with 9/16" socket wrench using Impelpro Impeller Puller pulling out impeller in a tight space

Use a 9/16” wrench or socket to continue to tighten the bolt which will remove the impeller.
***If the teeth did not set into the impeller, please redo step 4 and tighten the thumbscrew tighter by hand.

Pro Tips:

Lube threads lightly before every use for smooth operation.
Avoid setting the arms on the cam inside the pump housing.
If the impeller is badly stuck, apply steady pressure with the wrench — the bearing system does the heavy lifting.

Step-by-Step Instructions (PDF)

Download the PDF Instructions